Home 
Products Enersol Solar Pool Heating Automatic Solar Controller
Products Enersol Solar Pool Heating Automatic Solar Controller
| Automatic Solar Controller |
|
The AquaSolar® system from GoldLine Controls gives you total solar system control with digital display of pool temperature and solar system temperature. Plus, full system diagnostic LED's. The Aqua Solar is set by a single dial adjustment for desired pool temperature. The AquaSolar® offers selectable high limit, programmable re circulation freeze protection and nocturnal cooling to customize any installation. Automatic Solar Controller - $599.00 ea. Features:
Included with Controller:3 way valve
Actuator
Control Box
Roof and Water sensors
Plug Cord
Sensor Wire
NOTE: All prices are quoted in Canadian Dollars (CDN$), and do not include shipping, or tax(s), as applicable. All prices subject to change without notice. Resources:Sensors:Installation of the 10K water sensor:Drill a 5/16" hole into the incoming water pipe, usually between the filter and diverter valve (feed line).
Install the plastic dylinder shaped sensor into the 1 1/2" PVC pipe to sense the water temperature.
Wires go through the hole in the stainless gear clamp and are clamped tight.
Use wire connectors (marr caps) for connecting the sensor leads to the sensor wire (2 line phone cord).
Tie a knot in the cable wire and sensor leads to act as a strain relief. Wrap with electrical tape for extra protection.
Installation of the 10k roof sensor:Install the black sensor on the roof where it receives sunlight similar to the solar collectors. Install on the roof, not on the panels.
Use the TEK screw to mount to the roof.
Use wire connectors (marr caps) for connecting the sensor leads to the sensor wire (2 line phone cord).
Tie a knot in the cable wire and sensor leads to act as a strain relief. Wrap with electrical tape for extra protection.
|
